TECHNICAL DRAWING LI TEST ONE - EMAGK SITE

Latest

This website was designed to help college student especially those who takes engineering course for review, past paper and other learning material. And teacher for review.

Tuesday, March 31, 2020

TECHNICAL DRAWING LI TEST ONE


L I T/DRAWING.
INSTRUCTION:
i. Attempt all Questions
ii. Write your examination number on every page of your answer booklet.
1.       a) List ten drawing tools and state their uses.
b) Mention two types of set square.
c) Mention two types of fixed set square.
2.       a)  There are two types of drawing sheet layouts commonly used in Technical drawing. Mention them and draw a simple sketch to indicate each one of them.
b) Using 45 – 45 degrees setsquare draw the line at 45 degree of 75mm long.
3.       With the help of neat sketch list down five types of line.
4.       a) Draw a horizontal line XY 80mm long and then bisect it by line MN.
b) Draw vertical line AB 60mm long and then bisect it at c.
5.       a) Mention five main features to be shown in Title block.
b) Using 60 -30 degree set square draw line FG 80mm long at angle of 30 degree  and bisect it at H.

No comments:

Post a Comment